CalderaSpas Moorea Owner's Manual Page 4

  • Download
  • Add to my manuals
  • Print
  • Page
    / 44
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 3
2
IMPORTANT SAFETY INSTRUCTIONS
READ AND FOLLOW ALL INSTRUCTIONS
AVOIDING THE RISK TO CHILDREN
Danger:
RISK OF CHILD DROWNING. Extreme caution must be exercised to prevent unauthorized access by children. To avoid accidents, ensure that children cannot use a
spa unless they are supervised at all times.
Warning:
To reduce the risk of injury, do not permit children to use this spa unless they are closely supervised at all times.•
To reduce the risk of injury, lower water temperatures are recommended for young children. Children are especially sensitive to hot water.•
DO:
Make sure you always lock the child resistant locks after using the spa for your children’s safety. Every Caldera•
®
spa is equipped with a locking cover that
meets the ASTM F1346-91 Standard for Safety Covers.
Test the water temperature with your hand before allowing children to enter the spa to be sure that it’s comfortable. Children are especially sensitive to hot •
water.
Remind children that wet surfaces can be very slippery. Make sure that children are careful when entering, or exiting the spa.•
DOn’T:
Allow children to climb onto the spa cover.•
Allow children to have unsupervised access to the spa.•
AVOIDING THE RISK OF ELECTROCUTION
risk Of elecTrOcuTiOn
Connect only to a grounded source.•
Do not bury the power cord. A buried power cord may result in death, or serious personal injury due to electrocution if direct burial-type cable is not used, or if •
improper digging occurs.
A ground terminal (pressure wire connector) is provided on the control box inside the unit to permit connection of a minimum No. 10 AWG solid copper bonding •
conductor between this point and any metal equipment, metal water pipe, metal enclosures of electrical equipment, or conduit within five feet (1.5 m) of the unit
as needed to comply with local requirements.
Warning:
To reduce the risk of electrical shock, replace a damaged cord immediately. Failure to do so may result in death or serious personal injury due to electrocution.•
Your spa is provided with a Ground Fault Circuit Interrupter for user and equipment protection. To ensure proper operation of this important safety device, test •
according to the following instructions per electrical configuration.
230 volt, permanently installed models:
A ground terminal is provided on the terminal block located inside the control box. To reduce the risk of electric shock, connect this terminal to the grounding •
terminal of your electrical service or supply panel with a continuous green, insulated copper wire. The wire must be equivalent in size to the circuit conductors
supplying the equipment. In addition, a bonding terminal (pressure wire connector) is provided on the outside of the control box for bonding to local ground
points. To reduce the risk of electric shock, this connector should be bonded with a No. 10 AWG solid copper wire to any metal ladders, water pipes, or other
metal within 5 feet (1.5 m) of the spa to comply with local requirements. The means of disconnection must be readily accessible, but must be installed at least
5 feet (1.5 m) from the spa.
Your spa is provided with a suitably rated circuit breaker to open all ungrounded supply conductors.•
Your spa uses ground fault circuit interrupters in the electrical subpanel. Before each use of the spa and with the unit operating, push the TEST button on each •
breaker. The switch should click over to the “Trip” position. Wait 30 seconds and reset each GFCI breaker by switching it completely off and then completely
on. The switch should then stay on. If either of the interrupters does not perform in this manner, it is an indication of an electrical malfunction and the possibility
of an electric shock. Disconnect the power until the fault has been identified and corrected.
Danger: risk Of elecTrical sHOck
Install spa at least 5 feet (1.5 m) from all metal surfaces. A spa may be installed within 5 feet of a metal surface if each metal surface is permanently connected •
by a minimum No. 8 AWG solid copper conductor attached to the wire ground connector on the terminal box that is provided for this purpose if in accordance
with National Electrical Code ANSI/NMFPA70-1993.
Do not permit any electrical appliances, such as a light, telephone, radio, or television within 5 feet (1.5 m) of a spa. Failure to maintain a safe distance may •
result in death, or serious personal injury due to electrocution, if the appliance should fall into the spa.
SAFETY INFORMATION
Page view 3
1 2 3 4 5 6 7 8 9 ... 43 44

Comments to this Manuals

No comments