CalderaSpas Olympia Owner's Manual

Olympia • Cumberland® • Aventine®• San GabrielTM Highland SeriesOwner’s Manual

7Your Caldera ® spa has been thoroughly tested during the manufacturing process to ensure reliability and long-term customer satisfaction. A small amo

8SPA FEATURES112479105811610106688899931112 Air control1. Spa-side control panel2. Filter compartment 3. Temperature sensor 4. Spa light5. Drain/

Air control1. Spa-side control panel2. Filter compartment 3. Temperature sensor 4. Spa light5. Drain/suction fitting6. Outlet for optional ozon

JET MENUS10Left Pump Jet System• 8 Euro Jets in back left• 1 AdaptaFloTM Jet in back center• 2 AdaptaFlo Jets and 4 Euro Jets in back rightRight Pu

JET MENUS11Jet System• 1 AdaptaFloTM Jet in back left• 2 Euro Jets in back center• 1 AdaptaFlo Jet and 2 Euro Jets in back right• 1 AdaptaFlo

SPA-SIDE CONTROL OPERATIONYour spa-side control panel consists of an LED display and convenient touch pads that allow you to set the water temperature

LOCK FEATURESThe locking features, TEMPERATURE LOCK and SPA LOCK, are enabled from the control panel by a specific combination of buttons. Once enable

HYDRO JETSAdaptaFloTM Jets – The larger jets in your spa allow you to re-direct the jet stream by changing the position of the nozzle.You can also reg

Pathogen: A microorganism such as bacterium that cause disease.pH: The measure of the spa water’s acidity and alkalinity. The recommended pH for the s

16HOW TO ADD CHEMICALS TO THE SPA WATERIMPORTANT: All spa water chemicals (other than SPA FROG cartridges), including MPS Plus (shock), chlorine, gran

Owner’s ManualThis Owner’s Manual will acquaint you with the operation and general maintenance of your new spa. We suggest that you take some time to

17D. If the pH level is too high, the following may result:• The sanitizer is less effective.• Scale will form on the spa shell surface and the equ

WATER QUALITY AND MAINTENANCE18SPA FROG® WATER CARE SYSTEM (THE SPA FROG MINERAL CARTRIDGE IS NOT APPROVED FOR USE IN CANADA.)The SPA FROG Water Care

C. Maintaining the proper level of bromine during use is extremely important.D. If the bromine level is too low, bacteria and viruses can grow rapid

MONARCH ® OZONE SYSTEM (OPTIONAL)The Monarch high output ozone system is the only ozone purification system approved for installation in your Caldera®

The Monarch ® ozone system is practically maintenance-free because it is located within the spa’s equipment compartment. If bubbles are appearing at t

22Chlorine does not have an odor. The second is Chloramine, which is residue from chlorine already expended. Chloramines have a strong chlorine odor.

FILTER MAINTENANCEAt least once a week, check and clean the skimmer basket and weir to ensure proper filter flow. Remove leaves, foreign matter, and d

24To reinstall the spa pillow, carefully bend the pillow slightly to allow one of the pillow retainers to slip into the recess in the back of the pill

25MAINTENANCEECOTECH ® SPA CABINET (STANDARD ON OLYMPIA, CUMBERLAND® AND AVENTINE ®)The EcoTech cabinet consists of rigid polymers that combine the

3. Using the shop vac, remove the water starting with the jets at the top and moving to the ones at the bottom of the spa. NOTE: When removing the

TABLE OF CONTENTSSAFETY INSTRUCTIONS • Important Safety Instructions ... 1 • Important Spa Instructions ..

SPA TROUBLESHOOTING27If your spa doesn’t seem to be working the way you believe it should, please review the “START-UP” and “OPERATION” instructions i

Watkins Manufacturing Corporation (“Watkins”) warrants to the original consumer purchaser (“you”) the following about your new Olympia

WATKINS MANUFACTURING CORPORATION 1280 Park Center Drive, Vista CA 92081© 2007 Watkins Manufacturing Corporation P

NOTES30

NOTES31

x33Watkins Manufacturing CorporationVista, CaliforniaUSAThis manual contains installation, operating, maintenance and service information for the foll

IMPORTANT SAFETY INSTRUCTIONSREAD AND FOLLOW ALL INSTRUCTIONSAVOIDING THE RISK TO CHILDRENDANGER:• RISK OF CHILD DROWNING. Extreme caution must be ex

DANGER: RISK OF ELECTRICAL SHOCK• Install spa at least 5 feet (1.5 m) from all metal surfaces. A spa may be installed within 5 feet of a metal surfac

TO REDUCE THE RISK OF INJURY:• The water in the spa should never exceed 104°F (40°C). Water temperatures between 100°F (38°C) and 104°F (40°C) are co

DECK INSTALLATIONTo be certain your deck can support your spa, you must know the deck’s maximum load capacity. Consult a qualified building contractor

SELECTING THE VOLTAGE FOR YOUR SPAThe Cumberland ®, Aventine ®, and San Gabriel™ spas are designed to operate at either 115 or 230 volts, 60 Hz, while

230 VOLT WIRING INSTRUCTIONS NOTE: The subpanel must be placed within 100 feet of the main electrical service panel, and between 5 and 50 feet away fr