CalderaSpas Cascade Owner's Manual download pdf (Page 12)

SPA-SIDE CONTROL OPERATION

Your spa-side control panel consists of an LED display and convenient touch

pads that allow you to set the water temperature and adjust the skim/filter

cycle settings, as well as control the hydrotherapy jets, and light from

spa-side.

LED DISPLAY

The LED display on your spa-side control panel continually shows the spa’s

actual water temperature. In certain situations, it will also display other

messages. See TROUBLESHOOTING section.

TEMPERATURE CONTROL

The set temperature range is from 50°F to 104°F. The factory-set temperature

is 102°F. Whenever power is disconnected and then reconnected to the spa,

the water temperature will automatically seek this temperature, unless you set

it otherwise using the temperature controls.

Pressing the Temp Plus (+) button displays the spa’s set temperature. To

increase the set temperature, press the Temp Plus (+) button again, once for

each degree of increased temperature desired. If you hold the button down,

the set temperature will increase by one degree every half second.

Pressing the Temp Minus (-) button displays the spa’s set temperature. To

decrease the set temperature, press the Temp Minus (-) button again, once for

each degree of decreased temperature desired. If you hold the button down,

the set temperature will decrease by one degree every half second.

JET PUMP CONTROL

Pressing the Jet button changes the jet pump functions, depending on the number of presses:

Oympia Spa only:

1st press: Two-speed jet pump runs on low speed

2nd press: Two-speed jet pump runs on high speed

3rd press: One-and Two speed jet pumps run on high speed

4th press: One-speed jet pump runs on high speed

5th press: Both jet pumps are off.

Cascade and Cumberland

Spas only:

1st press: Two-speed jet pump runs on low speed

2nd press: Two-speed jet pump runs on high speed

3rd press: Jet pump off

• During filter cycles or when the thermostat is calling for heat, the pump’s low speed operates automatically and cannot be turned off by pressing the

Temp Plus (+) or Temp Minus (–) touch pad.

• The pump on high speed automatically turns off after operating for one hour. The pump on low speed automatically turns off after operating for one hour.

• When the jets are active, the JETS LED on the control panel will illuminate.

LIGHT CONTROL

Your Highland spa is equipped with a low-voltage spa light. Press the LIGHT button to turn it on. Press it a second time to turn it off. For your spa enjoyment, a blue and

a red lens cover have been included with the spa’s owner’s packet. The original clear lens is not removable – the red or blue colored lens can be snapped over the clear

lens to create the desired ambiance.

The light automatically turns off after six hours.

When the light is active, the LIGHT LED on the control panel will illuminate.

OPERATING INSTRUCTIONS

Set Temperature

Display

Filter

Cycle LED

Jets

LED

Light

LED

Temperature

Minus

Temperature

Plus

Jet

Button

Light

Button

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 27 28

Comments to this Manuals

No comments

CalderaSpas Cascade Owner's Manual Page 12

Comments to this Manuals

Related products and manuals for Above ground pools CalderaSpas Cascade